Table of Contents
Advertisement
Complete manual mesh:
Step
1
Select the Signal Strength LED MAC from the drop down menu. The
selections are also listed at the bottom of the screen. See Table 10 for more
information on this option.
2
Set Spanning Tree Protocol (STP) 802.1d to Enable unless you are sure
that there is no chance of a mesh loop. See Table 10 and
more information on this option.
3
Click Apply to accept the changes made on this screen.
4
At the left of the screen, click on Encryption to display the Wireless Mesh -
Encryption screen.
5
Choose the Encryption Type from the drop down menu. Choice is either
None or Static AES-CCM.
6
If you select AES-CCM, you must enter a 128-bit key as hexadecimal digits in
the Key field, or click on the Key Generator button which automatically
generates a randomized key.
Record the key number. You will need to use it later.
Note that this key is initially shown in plain text so you have the opportunity to
record or copy the key. Once the key is applied, the key is no longer
displayed in plain text.
7
Once you have selected the options you will use, click Apply.
TIP
Configure other multinodes in the mesh network following the instructions
given for Multinode 1 above.
Be sure that you have completed configuration of the multinode by visiting the
System Configuration, Wireless Access Point and System Services screens
and choosing the configuration options applicable to the wireless network.
You must set the Encryption type and encryption key (if required) to ensure that the mesh
is working correctly. The encryption key that you use on this screen must be the same for
any mesh node connected to this network in order for communication to occur. The
encryption type and key value for Mesh node 1 must be the same as for Mesh node 2 and
any other mesh node in the network.
R110
6/08
Action
OneWireless Multinode User's Guide
Wireless Mesh Configuration
Setting up wireless networks
Mesh loop
for
89
Advertisement
Table of Contents
