Ordering - GE D30 Instruction Manual

2.1 INTRODUCTION
52
Monitoring
2
50DD
D30
Table 2–2: OTHER DEVICE FUNCTIONS
FUNCTION
Breaker Arcing Current (I
Breaker Control
Contact Inputs (up to 96)
Contact Outputs (up to 64)
Control Pushbuttons
Digital Counters (8)
Digital Elements (48)
Direct Inputs/Outputs (32)
DNP 3.0 or IEC 60870-5-104
Communications
Event Recorder
Fault Detector and Fault Report
The D30 is available as a 19-inch rack horizontal mount unit or a reduced size (¾) vertical mount unit, and consists of the
following modules: CPU, faceplate, power supply, CPU, CT/VT, digital input/outputs, and inter-relay communications. Each
of these modules can be supplied in a number of configurations specified at the time of ordering. The information required
to completely specify the relay is provided in the following tables (see Chapter 3 for full details of relay modules).
Order codes are subject to change without notice. Refer to the GE Multilin ordering page at
trial.com/multilin/order.htm
NOTE
2-2
CLOSE TRIP
79
50P (2) 50_2 (2) 51P (2) 51_2 (2)
Line Distance Relay
Figure 2–1: SINGLE LINE DIAGRAM
FUNCTION
2
t) Fault Locator
FlexElements™ (8)
FlexLogic™ Equations
IEC 61850 Communications (optional)
Line Pickup
Metering: Current, Voltage, Power, Power
Factor, Frequency
Modbus Communications
Modbus User Map
Non-Volatile Latches
Non-Volatile Selector Switch
Oscillography
for the latest details concerning D30 ordering options.
D30 Line Distance Relay
59X 27X
21P (3) 67P (2) 67_2 (2) 68 78
Metering
50G (2) 51G (2)
FUNCTION
Setting Groups (6)
Time Synchronization over SNTP
Time Synchronization over SNTP
Transducer Inputs/Outputs
User Definable Displays
User Programmable LEDs
User Programmable Pushbuttons
User Programmable Self-Tests
Virtual Inputs (64)
Virtual Outputs (96)
VT Fuse Failure
2 PRODUCT DESCRIPTION
25 (2)
50N (2) 51N (2) 67N/G (2) 21G (3)
59P
Transducer
Inputs
27P (2)
59N
837764A1.CDR

2.1.2 ORDERING

http://www.GEindus-
GE Multilin