Synchrocheck; Tracking Frequency - GE D30 Instruction Manual

6 ACTUAL VALUES
MESSAGE
MESSAGE
MESSAGE
The metered values for real, reactive, and apparent power, as well as power factor, are displayed in this menu. The "SRC
1" text will be replaced by whatever name was programmed by the user for the associated source (see
TEM SETUP SIGNAL SOURCES
g) FREQUENCY METERING
PATH: ACTUAL VALUES METERING
FREQUENCY
SRC 1
The metered frequency values are displayed in this menu. The "SRC 1" text will be replaced by whatever name was pro-
grammed by the user for the associated source (see
is measured via software-implemented zero-crossing detection of an AC signal. The signal is either a
SOURCE FREQUENCY
Clarke transformation of three-phase voltages or currents, auxiliary voltage, or ground current as per source configuration
(see the
SYSTEM SETUP
final frequency measurement is passed through a validation filter that eliminates false readings due to signal distortions and
transients.
PATH: ACTUAL VALUES METERING

SYNCHROCHECK 1

MESSAGE
MESSAGE
The actual values menu for synchrocheck 2 is identical to that of synchrocheck 1. If a synchrocheck function setting is "Dis-
abled", the corresponding actual values menu item will not be displayed.
PATH: ACTUAL VALUES METERING

TRACKING FREQUENCY

The tracking frequency is displayed here. The frequency is tracked based on the selection of the reference source with the
FREQUENCY AND PHASE REFERENCE
Power System section of chapter 5 for additional details.
GE Multilin
SRC 1 POWER FACTOR
φa:
1.000
SRC 1 POWER FACTOR
φb:
1.000
SRC 1 POWER FACTOR
φc:
1.000
).
SOURCE SRC 1
SRC 1 FREQUENCY:
0.00 Hz
SETTINGS
settings). The signal used for frequency estimation is low-pass filtered. The
POWER SYSTEM
SYNCHROCHECK
SYNCHROCHECK 1 DELTA
VOLT: 0.000 V
SYNCHROCHECK 1 DELTA
PHASE: 0.0°
SYNCHROCHECK 1 DELTA
FREQ: 0.00 Hz
TRACKING FREQUENCY
TRACKING FREQUENCY:
60.00 Hz
setting in the
SETTINGS
D30 Line Distance Relay
FREQUENCY
SYSTEM SETUP SIGNAL SOURCES
SYNCHROCHECK 1(2)
SYSTEM SETUP POWER SYSTEM
6.3 METERING
SETTINGS SYS-
).
6.3.3 SYNCHROCHECK
6.3.4 TRACKING FREQUENCY
menu. Refer to the
6-15
6