Ordering - GE D30D00HCHF8AH6AM6BP8BX7A Instruction Manual

2 PRODUCT DESCRIPTION
Table 2–2: OTHER DEVICE FUNCTIONS
FUNCTION
Direct inputs and outputs (32)
Disconnect switches
DNP 3.0 or IEC 60870-5-104 protocol
Event recorder
a) OVERVIEW
The D30 is available as a 19-inch rack horizontal mount or reduced-size (¾) vertical unit and consists of the following mod-
ules: power supply, CPU, CT/VT, contact input and output, transducer input and output, and inter-relay communications.
Each of these modules can be supplied in a number of configurations specified at the time of ordering. The information
required to completely specify the relay is provided in the following tables (see chapter 3 for full details of relay modules).
Order codes are subject to change without notice. See the GE Multilin ordering page at
http://www.gedigitalenergy.com/multilin/order.htm
NOTE
The order code structure is dependent on the mounting option (horizontal or vertical) and the type of CT/VT modules
(enhanced diagnostic CT/VT modules or HardFiber
following sub-sections.
b) ORDER CODES WITH ENHANCED CT/VT MODULES
The order codes for the horizontal mount units are shown below.
Table 2–3: D30 ORDER CODES (HORIZONTAL UNITS)
D30 - * ** - * * * - F
BASE UNIT D30 | | | | |
CPU T | | | |
U | | | |
V | | | |
GE Multilin
FUNCTION
Non-volatile latches
Non-volatile selector switch
Oscillography
Setting groups (6)
for the latest options.
TM
process bus modules). The order code options are described in the
** - H ** - M ** - P ** - U **
| | | | |
| | | | |
| | | | |
| | | | |
D30 Line Distance Protection System
FUNCTION
Virtual outputs (96)
VT fuse failure
- W/X ** Full Size Horizontal Mount
| Base Unit
| RS485 and Three Multi-mode fiber 100Base-FX (SFP with LC)
| RS485 with 1 100Base-T Ethernet, SFP RJ-45 + 2 100Base-FX Ethernet, multimode, SFP with LC
| RS485 with 3 100Base-T Ethernet, SFP with RJ-45
2.1 INTRODUCTION
2

2.1.2 ORDERING

2-3