Set Date And Time; Relay Maintenance - GE D30 Instruction Manual

7.1 COMMANDS
7
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a com-
mand setting to "Yes" and pressing the ENTER key. After clearing data, the command setting automatically reverts to "No".
PATH: COMMANDS
COMMANDS

SET DATE AND TIME

The date and time can be entered here via the faceplate keypad only if the IRIG-B or SNTP signal is not in use. The time
setting is based on the 24-hour clock. The complete date, as a minimum, must be entered to allow execution of this com-
mand. The new time will take effect at the moment the ENTER key is clicked.
PATH: COMMANDS
COMMANDS

RELAY MAINTENANCE

This menu contains commands for relay maintenance purposes. Commands are activated by changing a command setting
to "Yes" and pressing the ENTER key. The command setting will then automatically revert to "No".
The
PERFORM LAMPTEST
command causes the relay to scan the backplane for the hardware modules and update the order code to
ORDER CODE
match. If an update occurs, the following message is shown.
There is no impact if there have been no changes to the hardware modules. When an update does not occur, the
message will be shown.
CODE NOT UPDATED
7-2
CLEAR BREAKER 2
ARCING AMPS? No
CLEAR UNAUTHORIZED
ACCESS? No
CLEAR DIRECT I/O
COUNTERS? No
CLEAR TELEPROTECT
COUNTERS? No
CLEAR ALL RELAY
RECORDS? No
SET DATE AND TIME
SET DATE AND TIME:
2000/01/14 13:47:03
RELAY MAINTENANCE
PERFORM LAMPTEST?
No
UPDATE ORDER CODE?
No
command turns on all faceplate LEDs and display pixels for a short duration. The
UPDATING...
PLEASE WAIT
D30 Line Distance Relay
7 COMMANDS AND TARGETS
Range: No, Yes
Range: No, Yes
Range: No, Yes. Valid only for units with Direct Input/
Output module.
Range: No, Yes
Range: No, Yes
7.1.4 SET DATE AND TIME
(YYYY/MM/DD HH:MM:SS)
7.1.5 RELAY MAINTENANCE
Range: No, Yes
Range: No, Yes
UPDATE
ORDER
GE Multilin