Dell PowerEdge R530 Owner's Manual page 15

Item Indicator, button, or connector
4 iDRAC8 Enterprise port
(optional)
5 Full-height PCIe expansion card
slots (2)
6 Redundant power supply unit
7 Non-Redundant Power Supply
Unit
8 Half Height PCIe expansion card
slots (5)
9 Ethernet connectors (2)
10 System identification port
11 System identification button
12 USB connector
13 USB connector
14 Video/VGA port
Icon Description
Use the iDRAC8 Enterprise port to remotely access iDRAC. For
more information, see the Integrated Dell Remote Access Controller
User's Guide at Dell.com/idracmanuals.
Enables you to connect up to two full-height PCI Express expansion
cards.
AC
Or
DC
For information about supported PSUs, see the Technical
specifications section.
450 W
For information about supported PSUs, see the Technical
specifications section.
Allows you to connect PCIe expansion cards.
Integrated 10/100/1000 Mbps NIC connector
Use the system identification port to connect the system status
indicator assembly through the optional cable management arm.
Press the system ID button:
• To locate a particular system within a rack.
• To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE:
system ID button is enabled in the iDRAC setup.
NOTE:
and hold the system ID button (for more than five
seconds) to enter the BIOS progress mode.
Enables you to connect USB devices to the system. This port is
USB 3.0-compliant.
Enables you to connect USB devices to the system. This port is
USB 2.0-compliant.
Use the video/VGA port to connect a display to the system. For
more information about the supported video/VGA port, see the
Technical specifications section.
495 W EPP, 750 W EPP or 1100 W EPP
750 W
To reset iDRAC using system ID, ensure that the
If the system stops responding during POST, press
Dell PowerEdge R530 system overview 15