Dell PowerEdge R530 Owner's Manual page 157

1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
Steps
1 Unpack the new system board assembly.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.
2 Hold the touch points and lower the system board into the chassis.
3 Push the system board toward the back of the chassis until the board clicks into place.
Figure 87. Installing the system board
1 system board
Next steps
1 Install the Trusted Platform Module (TPM). For more information about TPM, see
2 Install / connect the following components:
a integrated storage controller card
b internal USB key (if installed)
c internal dual SD module
d the expansion card riser
e heat sink(s)/heat sink blank(s) and processors(s)/processor blank(s)
2 system board holder
Trusted Platform
Installing and removing system components
Module.
157