Dell PowerEdge R530 Owner's Manual page 69

2 Follow the procedure listed in the Before working inside your system section.
3 If connected, disconnect the cables from expansion card (s).
NOTE: If required, close the expansion card latch on the cooling shroud to release the full length card.
4 If installed, remove the expansion card riser.
CAUTION: Never operate your system with the cooling shroud removed. The system may get overheated quickly, resulting in
shutdown of the system and loss of data.
Step
By holding the sides of the cooling shroud, lift the cooling shroud away from the system.
Figure 18. Removing the cooling shroud
1 cooling shroud
3 chassis intrusion switch connector on system board
5 cooling shroud alignment pins
Next steps
1 Reinstall the cooling shroud.
2 If removed, reinstall the optional PCIe expansion card riser.
3 If disconnected, connect the cables to the expansion card(s).
4 If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
5 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
Removing the optional expansion card riser
Removing an expansion card from the expansion card riser
Installing an expansion card into the expansion card riser
Installing the optional expansion card riser
Installing the cooling shroud
2 chassis intrusion switch
4 cooling shroud alignment slots
Installing and removing system components 69