Front Bezel (Optional); Removing The Optional Front Bezel - Dell PowerEdge R530 Owner's Manual

You need the following tools to assemble the cables for a DC power supply unit.
• AMP 90871-1 hand-crimping tool or equivalent
• Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).

Front bezel (optional)

The front bezel is attached to the front side of the server and prevents accidents while removing the hard drive or when pressing the reset
or power button. The front bezel can also be locked for additional security.

Removing the optional front bezel

Prerequisite
Follow the safety guidelines listed in the Safety instructions section.
Steps
1 Locate and remove the bezel key.
NOTE: The bezel key is attached to the back of the bezel.
2 Unlock the bezel by using the key.
3 Slide the release latch up and pull the left end of the bezel.
4 Unhook the right end, and remove the bezel.
Figure 12. Removing the optional front bezel
1 release latch
3 front bezel
2 bezel lock
Installing and removing system components 63