Dell PowerEdge R530 Owner's Manual page 121

NOTE: You can update the system BIOS by using the Dell Lifecycle Controller.
NOTE: To ensure proper system cooling, you must install a processor blank in any empty processor socket.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
4 Remove the cooling shroud.
NOTE: If required, close the expansion card latch on the cooling shroud to release the full length card.
5 If applicable, disconnect the power or data cables from expansion card (s).
6 If required, remove the expansion card riser.
7 Remove the heat sink.
WARNING: The processor is hot to touch for some time after the system has been powered down. Allow the processor to cool
before removing it.
CAUTION: The processor is held in its socket under strong pressure. Be aware that the release lever can spring up suddenly if not
firmly grasped.
Steps
1 Release the open first socket lever near the unlock icon
2 Release the close first socket release lever near the lock icon
90 degrees upward.
3 Lower the open first socket-release lever to lift the processor shield.
4 Hold the tab on the processor shield and lift the processor shield until the open first socket-release lever lifts up.
CAUTION: The socket pins are fragile and can be permanently damaged. Be careful not to bend the pins in the socket
when removing the processor out of the socket.
5 Lift the processor out of the socket and leave the open first socket-release lever up.
NOTE: If you are permanently removing the processor, you must install a socket protective cap in the vacant socket to
protect the socket pins and keep the socket free of dust.
NOTE: After removing the processor, place it in an anti-static container for reuse, return, or temporary storage. Do not
touch the bottom of the processor. Touch only the side edges of the processor.
by pushing the lever down and out from under the tab.
by pushing the lever down and out from under the tab. Lift the lever
Installing and removing system components 121