Dell PowerEdge R530 Owner's Manual page 134

3 Reinstall the cooling shroud.
4 If applicable open the expansion card latch on the cooling shroud to secure the full length expansion card.
5 Connect the power cable to the back of the PSU unit and secure the power cables to the cable strap.
6 Reconnect the power cable to the power source.
7 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
Removing the cooling shroud
Removing the optional expansion card riser
Installing the optional expansion card riser
Installing the cooling shroud
Installing a non redundant AC power supply unit (cabled)
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the cooling shroud.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
4 If applicable, disconnect the power or data cables from expansion card (s).
5 If applicable, remove the expansion card riser
Steps
1 Unpack the new power supply unit (PSU).
2 Slide the new PSU into the PSU cage until the PSU is fully seated.
3 Tighten the screw to secure the PSU to the chassis.
4 Connect all the power cables to the system board and hard drive backplane.
134 Installing and removing system components