Dell PowerEdge R530 Owner's Manual page 52

Option Description
Option
Drive Type
Capacity
Port J Sets the drive type of the selected device. For Embedded SATA settings in ATA mode, set this field to Auto to
enable BIOS support. Set it to OFF to turn off BIOS support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Related link
SATA Settings
Viewing SATA Settings
Integrated Devices
You can use the Integrated Devices screen to view and configure the settings of all integrated devices including the video controller,
integrated RAID controller, and the USB ports.
Related link
Integrated Devices details
System BIOS
Viewing Integrated Devices
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Integrated Devices.
Related link
Integrated Devices
Integrated Devices details
Integrated Devices details
The Integrated Devices screen details are explained as follows:
52 Pre-operating system management applications
Description
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is undefined for removable media
devices such as optical drives.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is undefined for removable media
devices such as optical drives.