Installing The Control Panel Board - Dell PowerEdge R530 Owner's Manual

3 control panel data cable
5 USB cable
Next steps
1 Reconnect the USB cable, control panel cable, and the LCD display module cable to the control panel board.
2 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system

Installing the control panel board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
Steps
1 Fit the control panel board in the chassis, while aligning the screw holes on the control panel board with the standoffs on the chassis.
2 Secure the control panel board to the chassis with the two screws.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the
connector is released before removal and insertion. The locking tab must be engaged after insertion.
3 Connect the USB cable, control panel cable, and the display module cable to the control panel board.
4 Route the power and data cables through the cable retention bracket.
150 Installing and removing system components
4 LCD display module cable