Dell PowerEdge R530 Owner's Manual page 135

Figure 67. Installing a non redundant AC PSU
1 standoff on the chassis
3 non-redundant PSU
5 P1 cable connector
7 P3 cable connector
Next steps
1 If applicable, install the PCIe expansion card riser.
2 If applicable, connect the required power or data cables to the expansion card(s).
3 Reinstall the cooling shroud.
4 If applicable open the expansion card latch on the cooling shroud to secure the full length expansion card.
5 Follow the procedure listed in the After working inside your system section.
2 screw
4 PSU unit cage
6 P2 cable connector
8 backplane connector
Installing and removing system components 135