Emergency - ferrotec genius Mounting Instructions

Mounting instruction Genius
Fault
Power supply cannot be
switched ON

12 Emergency

In the event of an emergency
Switch off the main switch if necessary
or turning anticlockwise/clockwise.
13 Dismantling / Disposal
13.1 Dismantling
Dismantling may only be performed by skilled personnel.
ure is followed before beginning dismantling work.
13.2 Disposal
The disposal must be of in accordance with local environmental protection regulations for
electrical equipment. Oil and cleaning materials must be disposed of in accordance with the
local laws and the instructions given in the material safety data sheets.
ing tools (brushes, cloths, etc.) must also be disposed of in accordance with the manufacturer's
instructions.
Version 2.0.6
Cause
Disconnected mains plug
The high-voltage connector is
not connected and locked
Safety conditions are no met
press the emergency stop button
. The emergency stop button is released by pulling out
76/78
Remedy
Connect the mains plug
Plug
Connect and lock the high-
voltage connector
Check safety interlock cir­
cuit
on the master control unit.
Make sure the shut down proced-
Contaminated clean-
Ferrotec GmbH