Mounting instruction Genius
D A N G E R !
8
Cleaning / Maintenance
D A N G E R !
qualified technicians only. Maintenance, cleaning and repair work
may only be carried out by such qualified technicians.
Maintenance and cleaning work to the evaporation controller is restricted to cleaning of the
housing
8.1
Visual inspection
The evaporation controller should be subjected to a general visual inspection regularly.
Check the evaporation controller for corrosion.
•
Check the evaporation controller for dust deposits as a result of air cooling.
•
Check the plug connections on the back for firm connection and fading as a result of
•
heat.
8.2
Cleaning
Clean the housing with a damp cloth monthly.
N O T I C E !
objects. Make sure no water gets inside the evaporation controller.
9
Interface cards / Interfaces for external com
ponents
All interfaces of the evaporation controller are located on cards plugged into the device
from the back.
9.1
The CPU-Card
The standard evaporation controller is equipped with the cards »CPUCard« and »Magnet
Card«. The gun rotation card »GRC« and the filament switch card »FSC« are optional.
The interfaces responsible for the communication besides the
described below.
Version 2.0.6
It is strictly forbidden to open the devices.
This chapter on maintenance is intended for
Do not use any aggressive cleaning additives or sharp
50/78
Systems are
C
ARRERA
Ferrotec GmbH