Table of Contents
Advertisement
Mounting instruction Genius
9.2
Magnetcurrent card
The magnet current connection (X117) is used to supply the magnet
coils of an electron beam evaporator. The cable (article no. 1-950003)
included in the scope of delivery must be used for evaporators from Fer
rotec.
The magnet current connection
designed as seven-pin round plug with the following PIN configuration.
1
2
3
4
5
6
Center
Data of coil actuation:
Output current:
Minimum resolution:
Switching frequency:
Voltage:
Deflection frequency:
9.3
Gun rotation card GRC (Option)
X118
is used to drive the motor of the multi pocket evaporator. The pin assignment is pre
defined for the operation with an Ferrotec multi pocket evaporator. To adapt a different
model of evaporator using menu
selectable.
X119
is used for the comunication with external devices. By
means of the menu
Options
ure each signal individually.
9.3.1
GRC Card, configuration of the GRC X118
Type of connector: 15-pin SUB-D-socket.
Function and pin layout of the connector:
Pin 6,7,8,14 are predefined to control the multi pocket evaporators.
6 optocoupled digital inputs (high = 8 V to 30 V, non polarity)
Input 7: 1 - 11
•
Input 8: 2 - 11
•
Input 9: 3 - 11
•
Input 10: 4 - 11
•
Input 11: 9 - 11
•
Input 12: 10 – 11
•
Electrically isolated voltage of 24 V/2 A and +15 V/100 mA, which is used to
supply the transistor outputs and can be used for the control cables. The pin
layout is listed in the attachments.
9.3.2
Relay Input- and Output X119
Conector type: 16 pin Phoenix-Connector with screw terminals
Functions and pinouts of the plug connector.
Version 2.0.6
X117
of the evaporation controller is
X-deflection
X-GND
-
-
Y-GND
Y-deflection
GND
-3 A to +3 A
10 Bit = 6 mA
80 kHz
24 V
0,2 Hz up to 100 Hz (waveform and amplitude
adjustable); max. 150 Hz for defocus option
Options
/
System Setup
/
System Setup
52/78
/
I/O
the pin assignment is free
/
I/O
it is possible to config
Fig. 19: Mag
net-Card
Fig. 20: GRC
Card
Ferrotec GmbH
Hide quick links:
Advertisement
Table of Contents
