Deactivating Cruise Control; Resuming The Cruise Control Set Speed - Triumph Explorer Owner's Handbook Manual

Deactivating Cruise Control

The cruise control can be deactivated by
one of the following methods:
• Roll the throttle twist grip fully
forward
• Pull the clutch lever
• Operate the front or rear brake
• Increase speed by using the throttle
for more than 60 seconds.
Upon deactivation, the cruise control
lamp will go out in the tachometer but
the SET indicator and set speed will still
be visible in the motorcycle status
display screen, indicating that the cruise
control set speed has been stored.
The cruise control set speed can be
resumed as described
provided the cruise control has not been
deactivated by turning the ignition
switch to the OFF position.
General Information
Resuming the Cruise Control Set
Speed
When resuming cruise control, always
ensure that the traffic conditions are
suitable for the set speed.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result in
loss of motorcycle control and an
accident.
Cruise control will be deactivated if one
of the following actions has been taken:
• Roll the throttle twist grip fully
forward
on page 79,
• Pull the clutch lever
• Operate the front or rear brake
• Increase speed by using the throttle
grip for more than 60 seconds.
The cruise control set speed can be
resumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be travelling at a
speed between 19 to 100 mph (30 to
160 km/h) and be in 3
A stored set speed is indicated by the
word SET, below the cruise control
symbol in the motorcycle status display
screen.
The stored set speed will remain in the
cruise control memory until the ignition
switch has been turned to the OFF
position.
Note:
• The cruise control set speed display
will flash until the resumed set speed
has been achieved.
Warning
rd
gear or higher.
79