Table of Contents
Advertisement
GENERAL INFORMATION
64
The word SET will be shown next to
the cruise control symbol. The cruise
control set speed will be shown and
the cruise control light will illuminate in
the tachometer indicating that cruise
control is active.
12:34
AM
5
5
4
4
50
3
3
2
2
MPH
5
1
1
0
E
1.
Cruise control symbol
2.
Cruise control set indicator
3.
Cruise control set speed
The cruise control system will maintain
the set speed until:
The
set
▼
described on page 64.
Cruise control is deactivated as
▼
described on page 64.
Adjusting the Set Speed While in
Cruise Control
To adjust the set speed while in cruise
control, press and release the:
RES/+ button to increase the speed
▼
SET/- button to decrease the speed.
▼
Each press of the buttons will adjust
the speed by 1 mph or 1 km/h. If
the
buttons
continuously increases or decreases in
single digit increments.
Stop pressing the adjust button when
the required speed is shown in the
display.
1
2
3
SET
50
6
6
7
7
8
8
9
9
10
10
F
speed
is
adjusted
are
held,
the
The cruise control set speed display will
flash until the new set speed has been
achieved.
If riding up a steep incline and cruise
control is unable to maintain the set
speed, the cruise control set speed
display will flash until the motorcycle
has regained the set speed.
c
15
o
An alternative way to increase the
speed in cruise control is to accelerate
to the required speed using the throttle
grip and then press the SET/- button.
Deactivating Cruise Control
The cruise control can be deactivated
by one of the following methods:
Roll the throttle twist grip fully
▼
forward.
Pull the clutch lever.
▼
Operate the front or rear brake.
▼
Increase speed by using the throttle
▼
for more than 60 seconds.
as
Upon deactivation, the cruise control
light will go out in the tachometer but
the SET indicator and set speed will
still be shown in the display screen,
indicating that the cruise control set
speed has been stored.
The cruise control set speed can be
resumed
provided the cruise control has not
been deactivated by turning the ignition
switch to the OFF position.
speed
as
described
on
page 65,
Advertisement
Chapters
Table of Contents
