Triumph Explorer Owner's Handbook Manual page 60

General Information
The riding mode highlighted in the
selection window is
activated once the time-out has elapsed,
and the following conditions
switching modes have been met.
Motorcycle Stationary - Engine Off
• The ignition is switched ON
• The engine stop switch is in the RUN
position.
Motorcycle Stationary - Engine On
• Neutral gear is selected or the clutch
is pulled in.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
• Close the throttle
• Pull the clutch in
• Ensure that the brakes are not
engaged (allow the motorcycle to
coast).
Note:
• It is not possible to select OFF-ROAD
or RIDER modes
motorcycle is in motion, if the ABS or
TC settings are set to Off-Road or
Off.
• In this case, the motorcycle must be
brought to a stop before the riding
mode change can take place.
60
Once the ABS, MAP, TC and TSAS
automatically settings
multifunction display will return to the
for home screen and the selected riding
mode will be displayed.
2
1
1. Home screen
2. Selected riding mode
The riding mode change is now complete
and normal riding can be resumed.
Note:
• The riding mode will default to ROAD
when the ignition is switched ON if
the OFF-ROAD or RIDER Mode was
whilst the
active the last time the ignition was
switched OFF, with ABS and/or TC
set to Off-Road or Off.
• Otherwise, the last selected riding
mode
activated
switched ON.
• If the mode icons are not visible
when the ignition switch is in the ON
position, ensure the engine stop
switch is in the RUN position.
have changed, the
OFF-ROAD
C N S AUTO
OFF-ROAD
47
1
MPG
12
2
MI
F 36
PSI
R 42
PSI
will be remembered and
when the ignition is