Universal Serial Bus (Usb) Socket - Triumph Explorer Owner's Handbook Manual

General Information
Universal Serial Bus (USB)
Socket
cjhl_1
1. USB socket
A USB socket is provided, located under
the passenger seat. The connector
provides a 5 Volt, 2 Amp power supply
which is suitable for charging electronic
devices such as mobile phones, cameras
and GPS devices.
To access the USB socket remove the
passenger seat.
Remove the cap from the USB socket.
Connect your device using a suitable
USB cable, then stow the device and
USB cable in the space available under
the passenger seat.
Warning
The USB socket is not waterproof
unless the waterproof cap is installed.
Do not connect electronic devices
whilst it is raining.
Water in the USB socket could lead to
an electrical problem, resulting in
motorcycle damage, loss of motorcycle
control and an accident.
100
Caution
Make sure that all electronic devices
and cables are safely secured under
the seat when riding.
Make sure there is sufficient space
surrounding any electronic devices for
the seat to close without causing any
damage to the electronic device or the
motorcycle.
1
Fit the passenger seat, ensuring that
neither the device or USB cable is
trapped.
Turn the ignition on and start the
engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this will discharge the
battery.
When your device has finished charging,
Remove the passenger
disconnect the device.
Refit the USB socket cap and refit the
passenger seat.
Note:
• The USB socket is protected by a
chassis ECM, which will automatically
cut power to the socket in the event
of an overload.
• Power can be restored to the USB
socket by turning the ignition switch
off then on again, provided that the
socket is not still overloaded.
seat and