Storage - Dahua NVR100 series User Manual

Parameter
Alarm
upload
Send
Email
Buzzer
Log
5.10.3.9 Alarm Out
The alarm output interface is shown as below. See Figure 5-100
Here you can set alarm output mode: auto/manual/stop.

5.10.4 Storage

5.10.4.1 Schedule
In this interfaces, you can add or remove the schedule record setup. See Figure 5-101.
There are four record modes: general (auto), motion detect, alarm and MD&alarm. There are six periods
in one day.
You can view the current time period setup from the color bar.

Green color stands for the general record/snapshot.

Yellow color stands for the motion detect record/snapshot..

Red color stands for the alarm record/snapshot.

Blue color stands for MD&alarm record/snapshot.
Function
System can upload the alarm signal to the center (Including alarm
center.
If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
Check the box here, system can record the network event alarm log.
Figure 5-100
441