Dahua NVR100 series User Manual page 312

Hide thumbs Also See for NVR100 series:

Table of Contents

Finally, you can set the alarm input as the local alarm and then select the record channel. The

select channel begins alarm record when an alarm occurred. Please note system begins the

alarm record instead of the MD record if the local alarm and MD event occurred at the same

Tour: Here you can enable tour function when an alarm occurs. System supports 1/8-window tour.

Please go to chapter4.3.6.2 Display for tour interval setup. Please note the tour setup here has

higher priority than the tour setup you set in the Display interface. Once there two tours are both

enabled, system can enable the alarm tour as you set here when an alarm occurred. If there is no

alarm, system implements the tour setup in the Display interface.

Snapshot: You can enable this function to snapshot image when an alarm occurs.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.

Figure 4-150