Dahua NVR100 series User Manual page 245

4.3.6.4 Preview Tour Parameters
Set preview display mode, channel display sequence and tour setup.

Set preview display mode: On the preview interface, right click mouse, you can view right-click menu.
Now you can select preview window amount and channel.

Set channel display mode: On the preview interface, if you want to change channel 1 and channel 16
position, please right click channel 1 video window and then drag to the channel 16 video window,
release button, you can change channel 1 and channel 16 position.

Tour setup: Here you can set preview window channel display mode and interval. Please follow the
steps listed below.
From Main menu->Setting->System->Display->Tour, you can see an interface shown as in Figure 4-77.
Here you can set tour parameter.

Enable tour: Check the box here to enable tour function. The general tour supports all types of
window split mode.

Interval: Input proper interval value here. The value ranges from 1-120 seconds.

Motion tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Video detect->Motion detect to enable tour function.

Alarm tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Alarm to enable tour function.

Window split: It is to set window split mode.
Figure 4-76
235