Dahua NVR100 series User Manual page 208

Hide thumbs Also See for NVR100 series:

Table of Contents

 Channel No.: Input channel amount or click the Connect button to get the channel

amount of the remote device.

We recommend click Connect button to get remote device channel amount, the manual add

operation may result in failure if the input channel amount is not right.

 Remote channel No.: After getting the remote device channel amount, click Setup to

select a channel.

Click to select one or more remote channel numbers here.

 Channel: The local channel number you want to add. One channel name has

corresponding one channel number.

 Decode buffer: There are three items: realtime,local,fluent.

 Service type: There are four items: auto/TCP/UDP/MULTICAST(ONVIF device only)

 The default connection mode is TCP if the connection protocol is private.

 There are three items:TCP/UDP/MULTICAST if the connection protocol is ONVIF.

 There are two items: TCP/UDP if the connection protocol is from the third-party.

Click OK to add the camera to the device.

to change the remote device information. Click

to delete remote device. .