Hdd Installation; Nvr100/100-P Series - Dahua NVR100 series User Manual
Hide thumbs
Also See for NVR100 series:
- User manual (384 pages) ,
- User manual (411 pages) ,
- User manual (411 pages)
Table of Contents
Advertisement
The model number in the stick on the bottom of NVR is very important; please check according to your
purchase order.
The label in the rear panel is very important too. Usually we need you to represent the serial number
when we provide the service after sales.
3.4 HDD Installation
Important：
Please turn off the power before you replace the HDD.
The pictures listed below for reference only.
For the first time install, please be aware that whether the HDDs have been installed.
You can refer to the Appendix for HDD space information and recommended HDD brand. Please use
HDD of 7200rpm or higher. Usually we do not recommend the PC HDD.
Please follow the instructions below to install hard disk.
3.4.1 NVR100/100-P Series
Please make sure the metal surface of the HDD is facing up when you are installing!
This series NVR has only one 2.5-inch SATA HDD.
Please follow the instructions below to install HDD.
○
1
Draw out the HDD bracket
When you remove the HDD, please refer to the following figure to pull the spring up and then remove the
HDD.
○
2
Make sure the HDD metal
surface is facing up and then put
the
HDD
into
the
horizontally
. After the HDD is in
the proper position, the columns
on the two sides can lock the
screw holes of the HDD to secure
it.
○
3
Put the HDD into the device.
bracket
142
Advertisement
Table of Contents
