Dahua NVR100 series User Manual page 396

Parameter
RTSP port
HTTP port
TCP port
User
name/password
Channel No.
Remote
channel No.
Channel
Decode buffer
Service type
Change IP
On the searched devices list, check one or more device(s) at the same time. Click Modify IP button, you
can see the following interface. See Figure 5-24
Please refer to the following sheet for log parameter information.
Parameter
DHCP
Function
Input RTSP port of the remote device. The default setup is 554.
Note
Skip this item if the manufacture is private or customize.
Input HTTP port of the remote device. The default setup is 80.
Note
Skip this item if the manufacture is private or customize.
Input TCP port of the remote device. The default setup is 37777.
The user name and password to login the remote device.
Input channel amount or click the Connect button to get the channel amount
of the remote device.
Note
We recommend click Connect button to get remote device channel amount,
the manual add operation may result in failure if the input channel amount is
not right.
After getting the remote device channel amount, click Setup to select a
channel.
Note
Click to select one or more remote channel numbers here.
The local channel number you want to add. One channel name has
corresponding one channel number.
There are three item: realtime,local, fluent.
There are four items: auto/TCP/UDP/MULTICAST(ONVIF device only)
Note
 The default connection mode is TCP if the connection protocol is
private.
 There are three items:TCP/UDP/MULTICAST if the connection protocol
is ONVIF.
There are two items: TCP/UDP if the connection protocol is from the

third-party.
Function
Check the box here, system can auto allocate the IP
address. The IP address, subnet mask, default
gateway are reference only.
386