Quick Start Guide - Emerson Rosemount 1057 Instruction Manual

Quick Start Guide

1. Refer to Section 2 for mechanical installation instructions.
2. Wire sensor(s) to the signal boards. See
additional details. Make current output, alarm relay and power connections.
3. Once connections are secured and verified, close panel and apply power to the analyzer.
WARNING
4. When the analyzer is powered up for the first time, Quick Start screens appear. Quick Start operating tips are as
follows:
a. A backlit field shows the position of the cursor.
b. To move the cursor left or right, use the keys to the left or right of the ENTER key. To scroll up or down or to
increase or decrease the value of a digit use the keys above and below the ENTER key . Use the left or right keys to
move the decimal point.
c. Press ENTER to store a setting. Press EXIT to leave without storing changes. Pressing EXIT during Quick Start
returns the display to the initial start-up screen (select language).
5. Complete the steps as shown in the Quick Start Guide flow diagram,
6. After the last step, the main display appears. The outputs are assigned to default values.
7. To change output, and temperature-related settings, go to the main menu and choose Program. Follow the
prompts. For a general guide to the Program menu, see the Quick Reference Guide,
8. To return the analyzer to the default settings, choose Reset Analyzer under the Program menu.
Quick Start Guide
Section 3 for wiring instructions. Refer to the sensor instruction sheet for
Figure A .
Figure B.
iii