Sensor Type - Emerson Rosemount 1057 Instruction Manual

Instruction Manual
LIQ-MAN-1057
A detailed flow diagram
of this section to guide you through all basic programming and configuration functions.
To configure the contacting conductivity measurement board:
1. Press MENU
2. Scroll down to Program. Press ENTER.
3. Scroll down to Measurement. Press ENTER.
4. Select Sensor 1 or Sensor 2 corresponding to contacting conductivity.
Press ENTER.
The
To program any displayed function, scroll to the desired item and press ENTER.
The following sub-sections provide you with the initial display screen that appears for each
configuration function. Use the flow diagram for contacting conductivity programming at the end of
this section and the Model 1057 live screen prompts for each function to complete configuration
and programming.
6.4.2

Sensor Type

The display screen for selecting 2-Electrode or 4-Electrode Type sensors is
shown. The default value is displayed in bold type. Refer to configuring
contacting measurements flow diagram
6.4.3 Measure
The display
The default value is displayed in bold type. Refer to configuring
contacting measurements flow diagram
6.4.4 Range
The display screen for selecting Range (Auto or a specific range) is shown.
The default value is displayed in bold type.
Note: Ranges are shown as conductance, not conductivity.
Refer to configuring contacting measurements flow diagram
complete this function.
Section 6: Programming Measurements
(Figure
adjacent screen appears
screen for
6-2) for contacting conductivity programming is provided at the end
(factory defaults
(Figure 6-2) to complete this function.
selecting the Measurement
(Figure 6-2) to complete this function.
Section 6: Programming Measurements
S1: 1.234µS/cm 1.234°C
S2: 12.34pH
S3: 12.34µS/cm 1.234°C
Type:
Measure:
Range:
Cell K: 1.00000/cm
are shown). RTD Offset: 0.00°C
RTD Slope:
Temp Comp: Slope
Slope:
Ref Temp:
Filter:
Custom Setup
S1: 1.234µS/cm 1.234°C
S2: 12.34pH
S3: 12.34µS/cm 1.234°C
2-Electrode
4-Electrode
S1: 1.234µS/cm 1.234°C
S2: 12.34pH
S3: 12.34µS/cm 1.234°C
is shown.
Conductivity
Resistivity
TDS
Salinity
NaOH (0-12%)
HCl (0-15%)
Low H2SO4
High H2SO4
NaCl (0-20%)
Custom Curve
S1: 1.234µS/cm 1.234°C
S2: 12.34pH
S3: 12.34µS/cm 1.234°C
Auto
50 µS
(Figure 6-2) to
500 µS
2000 µS
20 mS
200 mS
600 mS
April 2017
1.234°C
SN Configure
2-Electrode
Cond
Auto
0
2.00%/°C
25.0°C
2 sec
1.234°C
SN Type
1.234°C
SN Measurement
1.234°C
SN Range
35