Pitney Bowes DM800 Series Operator's Manual page 29

Parts of the
Mailing System
continued
SV61162 Rev. C
DM800™ Series Digital Mailing System Operating Guide
Connectors on the Back of the IntelliLink® Control Center
Internal Analog Phone Line Connector - Depending on the version of
your IntelliLink® Control Center, you may have an internal analog modem.
The Internal Analog Phone Line Connector label in the figure below inden-
tifies the PCN numbers of the IntelliLink® Control Centers that have an
internal analog modem and can connect directly to an analog phone line.
The PCN number is located on the bottom of your IntelliLink Control Cen-
ter.
The term analog phone line refers to a RJ11C or RJ11W compatible
(single line) telephone wall plug typically used for a residential phone or
facsimile hookup.
External Modem USB Connector - The IntelliLink® Control Center has
a connector for an external modem located on the right side of the control
center when viewed from the back. If your mailing system is not located
near an analog phone line and you need to remove the control center
when you perform feature updates or add postage, you can connect the
external modem to this connector. Refer to External Modem Connections
in this chapter.
IntelliLink® Control Center AC Adapter Receptacle - The receptacle for
the AC adapter is located on the back of the IntelliLink® Control
Center. If you need to remove the control center from the mailing system
base and move it to an analog telephone line, you plug the AC adapter into
this receptacle. When the control center is connected to the mailing sys-
tem base, access to the AC adapter is blocked as indicated by the dotted
line in the picture below.
Internal ana-
log phone line
connector*
*Use this to
connect to the
analog phone
line if the con-
trol center has
the following
PCN number:
1DXX
Control center installed on machine
base (AC adapter receptacle)*
*The dotted line indicates adapter
receptacle is covered by the base
USB modem
connector*
*Use this to
connect an ex-
ternal modem
if your control
center has the
following PCN
number: 1CXX
2-9