Remove The Product Id Label; Replace The Keypad Legend Inserts - Allen-Bradley PanelView Plus 6 User Manual

Chapter 5 Install and Replace Components

Remove the Product ID Label

Replace the Keypad Legend
Inserts
134
1. Disconnect power to the
terminal.
2. Remove the AC power wiring
from the power terminal block.
3. Insert a small, flat-blade
screwdriver into one of the two
slots below the AC module and
pry up carefully to release the tabs
from the slot.
4. Pull up on the front of the
module to release the back tabs.
5. Remove the DC power terminal
block and wiring from the
terminal.
You can replace the product ID label on the terminal with a custom label.
1. Remove the Allen-Bradley label by using your fingers or a tweezers.
2. Clean area with damp cloth and isopropyl alcohol.
3. Remove adhesive backing of new label and affix to the same location.
Legend strips are available as separate catalog numbers for keypad terminals,
except for the 400 keypad terminals. One side of the legend strips have default
key legends; the other side is blank for creating custom legends.
600 Terminals
The legend inserts for function keys F1...F10 are accessible from the back of the
unit and can be replaced with the terminal mounted in the panel.
Follow these steps to replace the legend insert.
1. Disconnect power to the terminal.
2. From the rear of the unit, pull the legend strip from the slot.
Rockwell Automation Publication 2711P-UM006E-EN-P - January 2017