Replace The Display Module - Allen-Bradley PanelView Plus 6 User Manual

Replace the Display Module

Follow these steps to replace a communication module.
1. Disconnect power from the terminal.
2. Disconnect communication cables from the module.
WARNING: Do not connect or disconnect any communication cable
with power applied to this device or any device on a network. An
electrical arc could cause an explosion in hazardous location
installations. Be sure power is removed or the area is known to be
nonhazardous before proceeding.
3. Remove the four screws that secure the communication module.
4. Carefully lift the communication module away from the logic module.
5. Install the new communication module by following steps 4...6 in
or Replace a Communication Module on page
Follow these steps to replace a 700, 1000, 1250, or 1500 display module.
Communication Module
Logic Module
Display Module
Follow these steps to replace the display module.
1. Disconnect power from the terminal.
2. Remove the terminal from the panel.
3. Detach the communication module, if attached, from the logic module by
removing the four screws.
4. Loosen the four captive screws that attach the logic module to the display
module.
5. Carefully lift the logic module from the display module.
6. Set the display module aside.
Rockwell Automation Publication 2711P-UM006E-EN-P - January 2017
Install and Replace Components Chapter 5
Install
121.
123