Clean The Display - Allen-Bradley PanelView Plus 6 User Manual

Clean the Display

Follow these steps to install an SD card in the card slot.
1. Verify that the SD card is locked or unlocked according to your preference:
• If unlocked, the terminal can write data to or read data from the card.
• If locked, the terminal can only read data from the card.
Unlocked
ATTENTION: Orient the SD card correctly before inserting into slot.
Forcing the card into the slot can damage the card or the terminal.
2. Insert the SD card firmly into the slot until you hear a click.
Press and release the SD card to eject the card from the slot.
• SD card volumes are named StorageCard2, StorageCard3,...
TIP
• SD card volumes and their physical characteristics are consistent with the
CompactFlash card used by other PanelView Plus products.
applications on CompactFlash cards to an SD card.
Use a protection antiglare overlay for easier cleaning of the display screen.
ATTENTION: Abrasive cleaners or solvents can damage the display. Do not
scrub or use brushes on the display.
Follow these steps to clean the display screen.
1. Disconnect power from the terminal.
2. Use a clean sponge or soft cloth with mild soap or detergent to clean the
display.
3. Dry the display with a chamois or moist cellulose sponge to avoid water
spots.
Remove fresh paint splashes and grease before drying by rubbing lightly with
isopropyl alcohol (70% concentration). Then wash the display by using mild soap
or detergent. Rinse with clean water.
Rockwell Automation Publication 2711P-UM006E-EN-P - January 2017
Install and Replace Components
Locked
Chapter 5
You can migrate
137