Replace The Battery - Allen-Bradley PanelView Plus 6 User Manual

Chapter 5 Install and Replace Components

Replace the Battery

130
The product has a lithium battery that is used by the real-time clock. The battery
is not used for backup or retention.
This product contains a sealed lithium battery which may need to be replaced
during the life of the product.
At the end of its life, the battery contained in this product should be collected
separately from any unsorted municipal waste.
The collection and recycling of batteries helps protect the environment and
contributes to the conservation of natural resources as valuable materials are
recovered.
ATTENTION: Shock Hazard
Failure to follow proper safety precautions could result in severe electrical shock or
damage to the terminal.
WARNING: There is a danger of explosion if the lithium battery or real-time
clock module in this product is incorrectly replaced. Do not replace the battery
or real-time clock module unless power has been removed and the area is
known to be nonhazardous.
Replace the battery with catalog number 2711P-RY2032 or an equivalent CR2032
coin cell battery.
Do not dispose of the lithium battery or real-time clock module in a fire or
incinerator. Dispose of used batteries in accordance with local regulations.
For safety information on the handling of lithium batteries, including handling and
disposal of leaking batteries, see Guidelines for Handling Lithium Batteries,
publication
400 and 600 Terminals
You can replace the battery with the terminal mounted in the panel. No special
tools are required to remove the battery.
Follow these steps to replace the battery in a 400 or 600 terminal.
1. Disconnect power from the terminal.
2. Unlatch the battery cover by pulling it straight out.
Rockwell Automation Publication 2711P-UM006E-EN-P - January 2017
AG 5-4.