Fastening Cycle Data - Stanley QB Expert Instruction Manual

Fastening Cycle Data

If required setup parameters for embedded protocols under Setup>Communications.
8.5 Fastening Cycle Data
Data for each fastening cycle is entered as a line in the fastening cycle record in each controller in the system
for its own spindle. However, when a system is ran in Synchornized mode the fastening cycle records get an
additional column labled Mult ID. This Multi ID is the same in each spindle in the muti-tool system for the same
fastening cycle ran. This allows the user to correlate the same run in each file.
174
QB Expert Alpha Controller