Rohs Compliance; Weee Compliance; Regulatory Notices For Radio Transmitter; Fcc Notice (Usa) - Stanley QB Expert Instruction Manual

1.3.2 RoHS Compliance

This product and its information meets the requirements of the European Restriction of Hazardous Substances
(RoHS) Directive (2011/65/EU).

1.3.3 WEEE Compliance

This product and its information meets the requirements of the European Waste of Electrical and Electronic
Equipment (WEEE) Directive (2011/65/EU). This product is marked with a crossed trashcan, see last figure below
in section 1.5.1 Warnings and Cautions.
1.4

Regulatory Notices for Radio Transmitter

It is mandatory that national, state and local codes and standards be followed.

1.4.1 FCC Notice (USA)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• reorient or relocate the receiving antenna,
• increase the separation between the equipment and receiver,
• connect the equipment into an outlet on a circuit different from that to which the receiver is connected, or
• consult the dealer or an experienced radio/TV technician for help.
This device contains transmitter module FCC ID: TE7WR702N.
• To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 20 cm
(7.87 in) or more should be maintained between the antenna of this device and persons during operation.
To ensure compliance, operations at closer distances than this are not recommended.

1.4.2 Canadian Compliance Notice

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions:
• This device may not cause interference, and
• This device must accept any interference, including interference that may cause undesired operation of the
device.
Cet appareil est conforme aux norms CNR exemptes de licence d'Industri Canada. Le
fonctionnement est soumis aux deux conditions suivantes:
• cet appareil ne doit pas provoquer d'interférences et
Instruction Manual
CAUTION
Introduction
5