Tool Installation; Sockets And Adapters - Stanley QB Expert Instruction Manual

5.1.6 Tool Installation

To Avoid Injury:
• Always wear eye and foot protection when installing equipment.
• Only use equipment and accessories specifically designed to operate with STANLEY assembly tools and use
them only in the manner for which they are intended.
• Do not install worn, damaged, or modified equipment that may be unsuitable for safe use.
• Train all operators in the safe and proper use of power tools. Operators should report any unsafe condition.
• Store idle tools and accessories in a safe location accessible only by trained persons.
• Disconnect power source (air, electricity, etc.) from tool prior to making adjustments, changing accessories,
or storing.
• Prior to operation, always check and test tools and accessories for damage, misalignment, binding or
any other condition that may affect operation. Maintenance and repair should be performed by qualified
personnel.
• Do not operate tools in or near explosive environments or in the presence of flammable liquids, gases,
dust, rain or other wet conditions.
• Keep the work area clean, well lit and uncluttered.
• Keep unauthorized personnel out of the work area.
DC Electric Tools & Controllers:
• Install tools in dry, indoor, non-flammable, and non-explosive environments only – Humidity: 0 to 95%
non-condensing and Temperature: 32 to 122 ºF (0 to +50 ºC).
• Installation, maintenance and programming should be performed by qualified personnel. Follow all
manufacturer installation instructions and applicable regulatory electrical codes and safety codes.
• Tool and controller plugs must match the outlet. This equipment must be earth grounded. Never modify a
plug in any way or use any adaptor plugs.
• Avoid body contact with electrically energized surfaces when holding a grounded tool.
• Prior to connecting a power source, always ensure the tool or controller is turned off.
• Limit controller access to trained and qualified personnel. Lock controller cabinets.
Turn the controllers off when removing or attaching tools.
STANLEY electric tools must be connected to a controller to operate. To ensure superior performance and
safe operation, use a STANLEY controller specifically designed for each tool. These instructions are specific to
STANLEY electric tools when used with STANLEY electric tool controllers and accessories. Some features may
not be applicable, performance may be degraded and some safety systems may not be available when tools are
connected to non-STANLEY controllers and accessories.

5.1.7 Sockets and Adapters

Use only industrial grade sockets and adapters (power bit and power or impact socket type).
Replace worn or damaged sockets that are unsuitable for safe operation immediately.
Always ensure drive socket is fully seated and locked into position before connecting power to tool.
5.1.7.1 Quick Change Chuck
NOTE: The chuck accepts 1/4" (6.35 mm) hex accessories and bit tips only.
Remove power or air before changing accessories and bits.
Instruction Manual
WARNING
Tool Operation
107