Keypad Mode; Controller Display Icons - Stanley QB Expert Instruction Manual

Display
2.7.7.3 Fastening Cycle Trace
Press the interactive TRACE button after scrolling through the log and highlighting a particular line. A Torque vs.
Time trace screen is drawn for the highlighted line.
Press the third interactive menu button to change the trace axes.
Use the up/down arrow keys and the interactive OK button or the Toggle button, or the number keys, to select
the type required.
1. Torque – Torque vs. time
2. Angle – Angle vs. time
3. Torque/Angle – Torque vs. Angle
4. Speed – Tool Speed vs. time.
Press the interactive BACK or EXIT buttons to leave the trace screen.

2.7.8 Keypad Mode

When Keypad Mode is set to Job or Task Select (see "3.1.4.1 General Tab" on page 60) at the run screen press
the Toggle button or a number on the keypad. A Job/Task window opens. Use the numbers on the keypad to
type in a Job/Task to be selected to run. Use the toggle or interactive OK button to accept and switch controller
operation to the selected Job/Task number.
When the Keypad Mode is set to PART ID (see "3.1.4.1 General Tab" on page 60) at the run screen press the
Toggle button or a number on the keypad. A PART ID window opens. Use the up/down arrows to write a character,
then the right arrow to move to the next character value to use as the PART ID. The numeric keypad may also be
used to write numbers as PART ID. Press the OK interactive menu button to save it. The limit is 32 characters.

2.7.9 Controller Display Icons

The QB Expert Alpha Controller has Icons in the upper left corner of the screen to indicate the following:
Icon
24
Status
Locked
Unlocked
Busy/working
Description
A password is required to make edits.
Edits are possible, automatically re-locks in time.
Wait for icon to clear before continuing.
QB Expert Alpha Controller