Table 4-7 Procedure For Changing The Local Setpoints; Table 4-8 Procedure For Switching Between Setpoints - Honeywell UDC3500 Product Manual

Changing the Setpoints

Table 4-7 Procedure for Changing the Local Setpoints

Step Operation
1 Select the
Setpoint
2 Change the
Value
3 Return to PV
Display
Switching between setpoints
You can switch between Local Setpoints or between Local and Remote Setpoints via the
SP SELECT key.
ATTENTION

Table 4-8 Procedure for Switching Between Setpoints

Step Operation
Select the
1
Setpoint
3/07
Press
Until you see:
Lower
Display
Upper Display = PV
Lower Display = SP or 2SP or 3SP or 4SP (Value)
To change the Local Setpoint to the value at which you want
or
the process maintained. The display "blinks" if you attempt
to enter setpoint values beyond the high and low limits..
Lower To store immediately or will store after 30 seconds.
Display
The REMOTE SETPOINT value cannot be changed at the keyboard.
Press
To switch between the four Local Setpoints and/or the
SP Select
Remote Setpoint. Whenever the active lo
ATTENTION "KEY ERROR" will appear in the
lower display, if:
• the remote setpoint or additional local setpoints are not
• you attempt to change the setpoint while a setpoint ramp
• if you attempt to change the setpoint with the setpoint
Appears to the left of the active setpoint
UDC3500 Universal Digital Controller Product Manual
Monitoring and Operating the Controller
configured as a setpoint source
is enabled, or
select function key disabled.
Result
Result
203