Figure 4-4 Functional Overview Block Diagram Of Internal Cascade Controller - Honeywell UDC3500 Product Manual

Monitoring and Operating the Controller
LOOP 2 – PRIMARY LOOP
S ETPOINT
S OURCE
S e e Loo p
Blo c k Diag ram
INTERNAL CAS CADE RULES
• Loop #2 is the prima ry (e xte rna l) loop.
• Loop #1 is the s e conda ry (inte rna l or s la ve ) loop.
• Loop #1 Re mote S e tpoint is fixe d a s loop #2 output.

Figure 4-4 Functional Overview Block Diagram of Internal Cascade Controller

Output Override
This instrument allows override of the Loop 1 output with the Loop 2 output based upon
which is larger or smaller. This can be accomplished by configuration (See Section 3.11)
or by Digital Input actuation (see Section 3.22).
The following rules apply for high/low override:
•
Only one physical output is required when override is enabled. It is the output
from Loop 1 because Loop 2's internal output is routed through the selector.
•
Loop 2 output can also be available at all times if desired.
•
In Manual mode, the Output may be overridden.
•
Does not apply for Three Position Step Control.
•
OTI on bottom display shows value of the internal Loop 1 output before any
override.
ATTENTION
The output of the unselected loop tracks the selected loop to within 5 % when in Auto mode to
eliminate windup. This tracking is done in the direction opposite to the Override Select
configuration; i.e., for High Select, the unselected output tracks within 5 % of the lower output,
and vice versa for Low Select.
232
PV S OURCE
S e e Blo c k
Diag ram
PID
CONTROL
ALGORITHM
INTERNAL
OUTPUT
S IGNAL
UDC3500 Universal Digital Controller Product Manual
LOOP 1 – S ECONDARY LOOP
S ETPOINT
S OURCE
S P
2S P
Lo c al S e tpoint
3S P
4S P
Re mo te S e tpo int
PV S OURCE
S e e Blo c k
Diag ram
PID
CONTROL
ALGORITHM
OUTPUT
To Final
Co ntro l
Eleme nt
3/07