Cisco Ip Phone 8800 Series Administration Guide For Cisco Unified Communications Manager - Cisco 8811 Administration Manual

Configure Network Settings
Procedure
Step 1
Press Applications
Step 2 To access the Network Settings menu, select Admin settings > Network setup
Step 3
To access the IPv6 settings menu, perform one of the following actions:
• With Wi-Fi disabled on the Cisco Unified Communications Manager: navigate to Ethernet Setup >
IPv6 setup.
• With Wi-Fi enabled on the Cisco Unified Communications Manager: navigate to Wi-Fi client Setup >
IPv6 setup.
Step 4 To enter IPv6 addresses:
a) Click in an input field.
b) Make your changes to the field (see the information below).
The following table describes the address formats.
Format
X:X:X:X:X:X:X:X
Compressed
• To enter a colon (:) in the address, press the asterisk (*) on the keypad.
• To enter hexadecimal digits a, b, and c, press 2 on the keypad, scroll to select the required digit, and
press Enter.
• To enter hexadecimal digits d, e, and f, press 3 on the keypad, scroll to select the required digit, and
press Enter.
• After you enter each part of the address, you press Apply or Revert .
Step 5 Change toggle fields using these steps:
a) If an option is set to No, press Yes to enable it. If the option is set to Yes, press No to disable it.
b) Press Apply to save your change, or Revert to discard it.

Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager

58
.
Description
Eight sets of hexadecimal digits separated by colons. Leading or trailing
zeros in each group may be omitted.
Example: 2001:db8:0:0:0:52:0:1
Collapse a single run of consecutive zero groups into a single group
represented by a double colon.
Example: 2001:db8::52:0:1