Cisco Ip Phone 8800 Series Administration Guide For Cisco Unified Communications Manager - Cisco 8811 Administration Manual

Cisco IP Phone Web Page
Item
Stream status
Host name
Sender packets
Sender octets
Sender codec
Sender reports sent
(see note)
Sender report time sent
(see note)
Rcvr lost packets
Avg jitter
Receiver codec
Receiver reports sent
(see note)
Receiver report time sent
(see note)
Rcvr packets
Rcvr octets

Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager

230
Description
Indication of whether streaming is active or not.
Unique, fixed name that is automatically assigned to the phone based on the
MAC address.
Total number of RTP data packets that the phone transmitted since it started
this connection. The value is 0 if the connection is set to receive-only mode.
Total number of payload octets that the phone transmitted in RTP data packets
since it started this connection. The value is 0 if the connection is set to
receive-only mode.
Type of audio encoding that is for the transmitted stream.
Number of times the RTCP Sender Report has been sent.
Internal time-stamp indication as to when the last RTCP Sender Report was
sent.
Total number of RTP data packets that have been lost since data reception started
on this connection. Defined as the number of expected packets less the number
of packets actually received, where the number of received packets includes any
that are late or are duplicates. The value displays as 0 if the connection was set
to send-only mode.
Estimate of mean deviation of the RTP data packet interarrival time, measured
in milliseconds. The value displays as 0 if the connection was set to send-only
mode.
Type of audio encoding that is used for the received stream.
Number of times the RTCP Receiver Reports have been sent.
Internal time-stamp indication as to when a RTCP Receiver Report was sent.
Total number of RTP data packets that the phone has received since data
reception started on this connection. Includes packets that were received from
different sources if this call is a multicast call. The value displays as 0 if the
connection was set to send-only mode.
Total number of payload octets that the device received in RTP data packets
since reception started on the connection. Includes packets that were received
from different sources if this call is a multicast call. The value displays as 0 if
the connection was set to send-only mode.