ProCurve 9304m Diagnostics Manual page 59

Table 3.5: Output from the debug spanning command (Continued)
This Field...
[C] 00
[D] 00
[E] 800000e052c37d40
[F] 00000000
[G] 800000e052c37d40
[H] 20
[I] 40
[J] 0000
[K] 0014
[L] 0002
[M] 000f
Syntax: [no] debug spanning
Possible values: N/A
Default value: N/A
ipv6 debug route-table disable-cache
This command is for HP internal use only.
ipv6 debug route-table main
This command is for HP internal use only.
ipv6 debug route-table rip
This command is for HP internal use only.
mm
Displays the contents of a specified address on every module.
EXAMPLE:
ProCurveRS# mm 0190044c
(4)0190044c: 0000 0000 0000 0000 0000 0000 0000 0000
(4)0190045c: 0000 0000 0000 0000 0000 0000 0000 0000
(4)0190046c: 0000 0000 0000 0000 0000 0000 0000 0000
(4)0190047c: 0000 0000 0000 0000 0000 0000 0000 0000
1e90044c: 0000044c 00000450 00000454 00000458
1e90045c: 0000045c 00000460 00000464 00000468
1e90046c: 0000046c 00000470 00000474 00000478
1e90047c: 0000047c 00000480 00000484 00000488
June 2005
Displays...
Command mode. This can be one of the following:
Config BPDU
00
Topology Change Notification BPDU
80
Acknowledgement of topology change. This can be one of the following:
No change
00
Change notification
80
Root ID.
Root path cost.
Bridge ID.
Port priority.
Port number.
Message age in 1/256 seconds.
Maximum age in 1/256 seconds.
Hello time in 1/256 seconds.
Forward delay in 1/256 seconds.
HP Diagnostic Command Reference
3 - 45