ProCurve 9304m Diagnostics Manual page 26

Diagnostic Guide for ProCurve 9300/9400 Series Routing Switches
debug ip dvmrp pruning
Displays DVMRP pruning information.
EXAMPLE:
ProCurveRS# debug ip dvmrp pruning
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ip dvmrp pruning command.
DVMRP: delete entry 00000003 idx 273
DVMRP: delete all entries for source 1.1.1.0
DVMRP: update fwd table by adding group 239.255.162.1 router 3.3.3.100 interface 9
DVMRP: update fwd table by adding group 239.255.162.2 router 3.3.3.100 interface 9
DVMRP: update fwd table by deleting group 239.255.162.1 router 3.3.3.100 interface 9
DVMRP: dvmrp delete prune state: Int6 Index 255 Prune Index 3
Syntax: [no] debug ip dvmrp pruning
Possible values: N/A
Default value: N/A
debug ip icmp events
Displays messages when ICMP events, including sending and receiving ICMP echo requests, occur.
EXAMPLE:
ProCurveRS# debug ip icmp events
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ip icmp events command.
ICMP: rcvd echo request packet of length 40 from 1.1.1.2
ICMP: send echo request packet of length 60 to 1.1.1.2
Syntax: [no] debug ip icmp events
Possible values: N/A
Default value: N/A
debug ip icmp packets
Displays information related to ICMP packets sent or received on the device.
EXAMPLE:
ProCurveRS# debug ip icmp packets
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ip icmp packets command.
ICMP:dst (1.2.3.4), src (0.0.0.0) echo request type
Syntax: [no] debug ip icmp packets
Possible values: N/A
Default value: N/A
3 - 12 June 2005