ProCurve 9304m Diagnostics Manual page 46

Diagnostic Guide for ProCurve 9300/9400 Series Routing Switches
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 ospf lsa-install command.
OSPFv3 LSA: Turnover type:IntraPrefix Lsa Id:0.0.0.0 AdvRouter:1.2.3.4: contents
not changed
OSPFv3 LSA: Turnover type:Router Lsa Id:0.0.0.0 AdvRouter:1.2.3.4: contents not
changed
OSPFv3 LSA: Turnover type:Router Lsa Id:0.0.0.0 AdvRouter:1.2.3.4: contents not
changed
OSPFv3 LSA: Turnover type:Router Lsa Id:0.0.0.0 AdvRouter:1.2.3.4: contents
changed
OSPFv3 LSA: Turnover type:IntraPrefix Lsa Id:0.0.0.0 AdvRouter:2.2.2.2: contents
changed
OSPFv3 LSA: Turnover type:Router Lsa Id:0.0.0.0 AdvRouter:2.2.2.2: contents
changed
Syntax: [no] debug ipv6 ospf lsa-install
Possible values: N/A
Default value: N/A
debug ipv6 ospf lsa-maxage
Displays information when an OSPF version 3 router removes an LSA from its link state database because the
router has not received any updates about the LSA in a specified amount of time.
EXAMPLE:
ProCurveRS debug ipv6 ospf lsa-maxage
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 ospf lsa-maxage command.
OSPFv3 LSA: Premature aging: Type: IntraPrefix, ID : 0, AdvRouter 1.2.3.4
OSPFv3 LSA: Premature aging: Type: IntraPrefix, ID : 0, AdvRouter 1.2.3.4
OSPFv3 LSA: remove MaxAge LSA:IntraPrefix Lsa Id:0.0.0.0 AdvRouter:1.2.3.4:
OSPFv3 LSA: remove MaxAge LSA:IntraPrefix Lsa Id:0.0.0.0 AdvRouter:2.2.2.2:
Syntax: [no] debug ipv6 ospf lsa-maxage
Possible values: N/A
Default value: N/A
debug ipv6 ospf lsa-refresh
Displays information when a link state database is refreshed with updated information about an existing LSA.
EXAMPLE:
ProCurveRS debug ipv6 ospf lsa-refresh
3 - 32 June 2005