ProCurve 9304m Diagnostics Manual page 28

Diagnostic Guide for ProCurve 9300/9400 Series Routing Switches
debug ip msdp message
Displays information when MSDP messages are sent or received on the device.
EXAMPLE:
ProCurveRS# debug ip msdp message
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ip msdp message command.
MSDP: 172.16.2.4: send keepalive message
MSDP: 172.16.2.4: TLV 4 Send Message to peer. length=3
MSDP: P=0 MSDP Header Rcvd: Len=3 Type=4
MSDP: 172.16.2.4: KEEP_ALIVE Received Type 00000004 State=4 Length=3
MSDP: 172.16.2.4: send keepalive message
MSDP: 172.16.2.4: TLV 4 Send Message to peer. length=3
MSDP: P=0 MSDP Header Rcvd: Len=3 Type=4
MSDP: 172.16.2.4: KEEP_ALIVE Received Type 00000004 State=4 Length=3
Syntax: [no] debug ip msdp message
Possible values: N/A
Default value: N/A
debug ip nat icmp
Displays information about ICMP packets whose source or destination matches a specified IP address.
EXAMPLE:
ProCurveRS# debug ip nat icmp 10.10.100.18
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ip nat icmp command.
NAT: icmp src 10.10.100.18 => trans 192.168.2.79 dst 204.71.202.127
NAT: 192.168.2.79 204.71.202.127 ID 35768 len 60 txfid 13 icmp (8/0/512/519)
NAT: 204.71.202.127 10.10.100.18 ID 11554 len 60 txfid 15 icmp (0/0/512/519)
Syntax: [no] debug ip nat icmp <ip-addr>
Possible values: A valid IP address. An IP address of 0.0.0.0 matches any ICMP packet.
Default value: N/A
debug ip nat udp
Displays information about UDP packets whose source or destination matches a specified IP address.
EXAMPLE:
ProCurveRS# debug ip nat udp 10.10.100.18
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ip nat udp command.
NAT: udp src 10.10.100.18:1561 => trans 192.168.2.79:65286 dst 192.168.3.11:53
NAT: 192.168.2.79:65286 192.168.3.11:53 ID 35512 len 58 txfid 13
NAT: 192.168.3.11:53 10.10.100.18:1560 ID 8453 len 346 txfid 15
Syntax: [no] debug ip nat udp <ip-addr>
Possible values: A valid IP address. An IP address of 0.0.0.0 matches any UDP packet.
3 - 14 June 2005