ProCurve 9304m Diagnostics Manual page 56

Diagnostic Guide for ProCurve 9300/9400 Series Routing Switches
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 ospf route-install command.
OSPFv3 ROUTE: route created: 3000:2::/64
ROUTE: Validate routing table
OSPFv3 : Validating route 3000:1::/64
OSPFv3 : Validating route 3000:2::/64
OSPFv3 : Route 3000:2::/64 added to RIB
Syntax: [no] debug ipv6 ospf route-install
Possible values: N/A
Default value: N/A
debug ipv6 packet
Displays basic header and port information for IPv6 packets transmitted and received by an HP device that
supports IPv6.
EXAMPLE:
ProCurveRS debug ipv6 packet
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 packet command.
IPv6_TX: 3000:1::2 => 3000:1::6 (00e0.52da.c347)
NextHeader:58, size:32 (72), vlan:1, Port: 136 (136)
Syntax: [no] debug ipv6 packet
Possible values: N/A
Default value: N/A
debug ipv6 ra
Displays information when an HP device that supports IPv6 sends and receives router solicitation and
advertisement messages, which verify the existence of a new router or an existing router that has become
unreachable.
EXAMPLE:
ProCurveRS debug ipv6 ra
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 ra command.
Periodical RA advertisement (200 seconds by default)
ICMPv6-RA: Sent RA to ff02::1 on port 3/9
ICMPv6-RA: prefix 3000:1::/64, lifetime 2592000/604800, onlink, autoconfig
ICMPv6-RA: Received RA from fe80::2e0:52ff:feda:c347 on port 3/9
Syntax: [no] debug ipv6 ra
Possible values: N/A
Default value: N/A
3 - 42 June 2005