ProCurve 9304m Diagnostics Manual page 41

Table 3.4 describes the contents of debug ip vrrp packet messages.
This Field... Displays...
rcvd. or send Indicates whether the packet was sent or received.
ver: VRRP version; RFC 2338 defines version 2.
type: VRRP packet type. Possible packet types are:
1 Advertisement
vrid: Virtual Router Identifier.
pri: Priority of the VRRP router.
#ip: The number of IP addresses contained in this VRRP advertisement.
aut: VRRP authentication type. Possible authentication types are:
0 No authentication
1 Simple text password
2 IP Authentication Header
adv:
chk: VRRP checksum.
Num of ip addr
Syntax: [no] debug ip vrrp packet
Possible values: N/A
Default value: N/A
debug ipv6 address
Displays information about packets with a source or destination address that matches the specified IPv6 address.
Entering the debug ipv6 address command also enables the debugging of IPv6 packets. For more information
about debugging IPv6 packets, see "debug ipv6 packet" on page 3-42.
EXAMPLE:
ProCurveRS# debug ipv6 address 3000:1::2
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 address command.
IPv6_TX: 3000:1::2 => 3000:1::6 (00e0.52da.c347)
NextHeader:58, size:32 (72), vlan:1, Port: 136 (136)
Syntax: [no] debug ipv6 address <ipv6-address>
Possible values: A valid IPv6 address.
Default value: N/A
June 2005
Table 3.4: Output from the debug ip vrrp packet command
HP Diagnostic Command Reference
3 - 27