ProCurve 9304m Diagnostics Manual page 49

After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 ospf nsm-status command.
OSPFv3 NSM[2.2.2.2]: Status change [Down]->[Init](HelloReceived)
OSPFv3 NSM[2.2.2.2]: Status change [Init]->[2-way](No Need Adjacency)
OSPFv3 NSM[2.2.2.2]: Status change [2-way]->[ExStart](Need Adjacency)
OSPFv3 NSM[2.2.2.2]: Status change [ExStart]->[ExChange](NegotiationDone)
OSPFv3 NSM[2.2.2.2]: Status change [ExChange]->[Loading](Requestlist Not Empty)
OSPFv3 NSM[2.2.2.2]: Status change [Loading]->[Full](LoadingDone)
Syntax: [no] debug ipv6 ospf nsm-status
Possible values: N/A
Default value: N/A
debug ipv6 ospf packet
Displays information about OSPF version 3 packets sent and received on an HP device that supports IPv6.
EXAMPLE:
ProCurveRS debug ipv6 ospf packet
After you enter this command, messages such as the following appear at the destination specified for debugging
output. You can turn off these messages with the no debug ipv6 ospf packet command.
OSPFv3: Snd Hello on ethe 3/9(fe80::204:80ff:fe2c:c048->ff02::5)
RtrID:1.2.3.4 DR:0.0.0.0 BDR:0.0.0.0
OSPFv3: Rcv Hello on ethe 3/9(fe80::2e0:52ff:feda:c347->ff02::5)
RtrID:2.2.2.2 DR:2.2.2.2 BDR:1.2.3.4
OSPFv3: NBR 2.2.2.2 declares 2.2.2.2 as DR
OSPFv3: NBR 2.2.2.2 declare 1.2.3.4 as BDR
OSPFv3: Rcv DbDesc on ethe 3/9(fe80::2e0:52ff:feda:c347->
fe80::204:80ff:fe2c:c048)
Syntax: [no] debug ipv6 ospf packet
Possible values: N/A
Default value: N/A
debug ipv6 ospf packet-dd
Displays information when an HP device that supports IPv6 sends or receives OSPF version 3 data description
packets.
EXAMPLE:
ProCurveRS debug ipv6 ospf packet-dd
June 2005
HP Diagnostic Command Reference
3 - 35