Program Radio Codeplug (Requires Rib) - Motorola HT 1000 User Manual

Program Radio
Codeplug (Requires
RIB)
CH
From the MAIN MENU, press F3 and then F8 to program the radio
codeplug.
MOTOROLA Radio Service Software
HT/JT1000/VISAR Model :
Serial:
GET-SAVE-CLONE
F1 - HELP
PROGRAMMING the radio will replace the contents of the radio's
F2 - Read Data from Radio
codeplug with the current contents of the workspace,
F3 - Get Workspace Data from Archive File
F4 -
F8 - program the radio's codeplug.
F5 - Clone (Copy) Data to another Radio
F10 - cancel request.
F6 -
F7 - Save Workspace Data to Archive File
Press F8 or F10.
F8 - Program Data into Radio
F9 -
F10 - EXIT, Return to Main Menu
F1 F2 F3 F4
HELP READ GET
RADIO FILE
This screen allows you to program the radio with the contents of the
current work space. A radio interface box (RIB) must be connected to the
computer's serial port and the power turned on before you perform this
operation.
The first time you press F8 in the GET/SAVE/PROGRAM screen, a
displayed prompt will request you to press F8 again to program the
radio with the contents of the work space or to press F10 to cancel the
request. If the programming process is successfully completed, you
will see the following message: "Radio Was Successfully Programmed".
You will then be returned to the GET/SAVE/PROGRAM screen
automatically.
Note: The time required to PROGRAM a codeplug will depend
directly on your computer type and the size of the codeplug
being programmed. The status of the programming operation
will be displayed on the screen.
Select a function key, F1-F10.
Get-Save-Clone Menu
-------------------
F5 F6 F7
CLONE SAVE PROGRAM
FILE
F8 F9 F10
EXIT
RADIO
65